Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0C52, P0C5C
Circuit voltage is less than 0.5 V.
P0C53, P0C5D
Circuit voltage is greater than 3.0 V.
P0A3F
SIN or COS signal is less than 2.3V. The motor control module cannot determine the motor position based upon the sensor signals.
P0A40
SIN or COS signal is greater than 4V. The motor control module detects a degraded motor position sensor signal.
P1B03
The motor control module is unable to track the motor position based upon the sensor signals.