Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Battery Hold Down Retainer Bolt | 25 N.m | 18 lb ft |
| Battery Tray to Battery Tray Reinforcement Bolts | 9 N.m | 80 lb in |
| Battery Tray to Auxiliary Underhood Electrical Center | 9 N.m | 80 lb in |
| Battery Tray Front Support Bolt | 9 N.m | 80 lb in |
| Engine Ground Strap to Front Dash Panel Nut | 9 N.m | 80 lb in |
| Engine Ground Strap to Left Cylinder Head Bolt | 16 N.m | 12 lb ft |
| Engine Wiring Harness Ground Lead Bolt | 9 N.m | 80 lb in |
| Generator Control Module Ground Strap Bolt | 9 N.m | 80 lb in |
| Negative Battery Cable to Engine Block Bolt | 50 N.m | 37 lb ft |
| Positive Battery Cable to Mega Fuse Stud Nut | 9 N.m | 80 lb in |
| Positive Battery Cable to Underhood Electrical Center Nut | 9 N.m | 80 lb in |