LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Electrical System - Hybrid) >> Repair Instructions >> Battery Positive Cable Replacement (12V Battery to Auxiliary BEC) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Positive Battery Cable Assembly
    GM1968603Courtesy of GENERAL MOTORS COMPANY
  1. Install the positive battery cable assembly (1) to the vehicle.
  2. Install the positive battery cable leads to the mega fuse and auxiliary BEC studs.
    3. Fig 2: Locating Positive Battery Cable Component
    GM1968594Courtesy of GENERAL MOTORS COMPANY
  3. Connect the positive battery cable connector (2) to the underhood BEC.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the positive battery cable nut (3) to the auxiliary BEC stud and tighten to 9 N.m (80 lb in).
  5. Install the positive battery cable nut (1) to the mega fuse stud and tighten to 9 N.m (80 lb in).
    6. Fig 3: View Of Junction Block & Retainers
    GM1702795Courtesy of GENERAL MOTORS COMPANY
  6. Ensure that the junction block retainers are in the open position (1).
  7. Position and align the junction block to the 4 bracket pivots (2), once the pivots are engaged, push the retainers down into the locked position (3).
    8. Fig 4: View Of Under Hood Junction Block Cover
    GM1702793Courtesy of GENERAL MOTORS COMPANY
  8. Install the underhood junction block cover.
    9. Fig 5: View Of BEC Cover
    GM1968591Courtesy of GENERAL MOTORS COMPANY
  9. Install the auxiliary BEC cover (1).
    10. Fig 6: Locating Battery Components
    GM1968006Courtesy of GENERAL MOTORS COMPANY
  10. Install the positive battery cable terminal (3) to the battery.
  11. Rotate the lever lock (1) clockwise until an audible click is heard in order to connect the positive battery cable.
  12. Position the positive battery cable insulating cover (2) over the positive terminal.
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals