Rear Case Installation
WARNING: This page is about a different variant/trim than selected.
Rear Case Installation
| Callout | Component Name |
|---|---|
| 1 | A/Trans Rear Case Gasket TIP: Verify that the sun gear - 3rd position is on the sun gear shaft assembly - 3rd position. |
| 2 | A/Trans Rear Case Assembly TIP: Be cautious of the park pawl rod, making sure it is lined up accurately thru the rear case assembly. |
| 3 | A/Trans Rear Case Bolt M8 x 1.25 x 30 (Qty: 12)
CAUTION:
Refer to Fastener Caution . Tighten Tighten bolt to 24-29 N.m (18-21 lb ft). |