Input Shaft Installation
WARNING: This page is about a different variant/trim than selected.
Input Shaft Installation
| Callout | Component Name |
|---|---|
| 1 | Internal Gear Retaining Ring - 1st Position TIP: Use a NEW retaining ring. Do not reuse the old retaining ring. |
| 2 | Input Shaft |
| 3 | Internal Gear - 1st Position |
| 4 | Input Shaft Assembly |
| 5 | A/Trans Torque Dampener Clutch Fluid Seal Ring TIP: Use a NEW seal ring. Do not reuse the old seal ring. |
| 6 | Input Shaft Fluid Seal Ring TIP: Use a NEW seal ring. Do not reuse the old seal ring. |
| 7 | Input Shaft Thrust Bearing |