Drive Motor with Generator Assembly Installation - 1st Position
WARNING: This page is about a different variant/trim than selected.
Drive Motor with Generator Assembly Installation - 1st Position
| Callout | Component Name |
|---|---|
| 1 | Drive Motor (w/Generator) Assembly - 1st Position
WARNING:
The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.
CAUTION:
Carefully feed temp sensor and resolver connector thru case opening or damage may occur. TIP: Replace with NEW seals while motor is on holding fixture. |
| 2 | Generator Drive Motor Bolt M6 x 1.0 x 20 (Qty: 3)
CAUTION:
Refer to Fastener Caution . TIP: Use Dexron VI to aid installation on O-rings for motor. Tighten Tighten bolt to 9-13 (80-115 lb in). Special Tools DT-48473 Motor Lift Plate |