Control Valve Assembly Removal
WARNING: This page is about a different variant/trim than selected.
Control Valve Assembly Removal
| Callout | Component Name |
|---|---|
| 1 | Control Solenoid (with Body and TCM) Valve Assembly Procedure Disconnect the wiring harness. |
| 2 | Shift Shaft Position Switch Procedure Disconnect the wiring harness. |
| 3 | A/Trans Wiring Harness Assembly Procedure Disconnect the wiring harness. |
| 4 | Control Valve Upper Body Bolt M6 x1.0 x 65 (Qty: 4) TIP: Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated. |
| 5 | Internal Wire Harness Side Bracket |
| 6 | Control Valve Upper Body Bolt M6 x 1.0 x 80 (Qty: 2) |
| 7 | Control (with Body and Valve) Valve Assembly
CAUTION:
Use care when handling the control valve body assembly. If dropped, damage to the control solenoid valve body assembly internal components, including the transmission control module (TCM), may result. |
| 8 | A/Trans Fluid Pump Seal Assembly TIP: Do not reuse the seal assembly. |
| 9 | Hybrid Low, 1-2 Clutch Regulator Valve Seal (Qty: 6) TIP: Do not reuse the seal assembly. |