Valve Body, Control Solenoid Torque Sequence

WARNING: This page is about a different variant/trim than selected.

Fig 1: Valve Body, Control Solenoid Tightening Sequence

GM1867839

Courtesy of GENERAL MOTORS COMPANY

Valve Body, Control Solenoid Torque Sequence

Callout	Component Name
CAUTION: Bolt torque sequencing is critical to the proper function of the control solenoid valve assembly. Failure to follow the required sequencing may result in transmission malfunction. Preliminary Procedure The 2 heat sink bolts must be tightened last.
1	Control Valve Body Bolts M6 x1.0 x 55 (Qty: 31) CAUTION: Refer to Fastener Caution . Procedure Tighten all 31 bolts in the sequence shown. Tighten 11 N.m (97 lb in)
2	Control Solenoid Valve Heat Sink (w/Body and TCM) Bolt M5 x.8 x 53 (Qty: 2). TIP: To ensure valve body to control solenoid assembly are properly aligned, inspect contact gap, see the following procedure. Tighten 7 N.m (62 lb in)