4th Clutch Piston Installation
WARNING: This page is about a different variant/trim than selected.
4th Clutch Piston Installation
| Callout | Component Name |
|---|---|
| 1 | 4th Clutch Piston TIP: Use a 2 inch spacer between DT-48056 spring compressor bridge and DT-47694 piston spring compressor. Special Tools
|
| 2 | 4th Clutch Piston Retaining Spring Assembly |
| 3 | 4th Clutch Piston Retaining Ring TIP: Do not reuse the retaining ring. |
| 4 | 4th Clutch Waved Plate |
| 5 | 4th Clutch Plate TIP: Alternate between steel and fiber clutch plates. |
| 6 | 4th Clutch Plate Assembly TIP: Alternate between steel and fiber clutch plates. |
| 7 | 4th Clutch Backing Plate |
| 8 | 4th Clutch Piston Retaining Ring TIP: Do not reuse the retaining ring. |