LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - Hybrid ( LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Removal - Right Side

Valve Rocker Arm Cover Removal - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Coils & Bracket
    GM1402028Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Do not remove the oil fill tube from the cover, unless service is required. If the oil fill tube has been removed from the cover, install a NEW tube during assembly.

  1. Remove the spark plug wires (724).
  2. Remove the ignition coil bracket studs (720).
  3. Remove the ignition coil and bracket assembly (719).
    4. Fig 2: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the ignition coil electrical connectors.
  5. Remove the bolts (723), coils (722), and wire harness (721) from the bracket (719), as required.
    6. Fig 3: View Of Valve Rocker Arm Cover & Bolts (Right)
    GM260084Courtesy of GENERAL MOTORS COMPANY
  6. Remove the valve rocker arm cover bolts and cover.
  7. If the valve rocker arm cover grommets are cracked or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt.
    8. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS COMPANY
  8. Remove and discard the valve rocker arm cover gasket (504) from the cover.
    9. Fig 5: Oil Fill Cap & Oil Fill Tube
    GM1559860Courtesy of GENERAL MOTORS COMPANY
  9. Remove the oil fill cap (424) from the oil fill tube (423).
  10. Remove the oil fill tube, as required.
  11. Discard the oil fill tube.
scientia non olet · About LEMON Manuals