LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - Hybrid ( LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Cleaning and Inspection

Valve Rocker Arm Cover Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Valve Rocker Arm Cover
    GM1559813Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • Do not use the valve rocker arm cover gasket again. Install a NEW gasket during assembly.
    • Remove the ignition coils before cleaning the cover in solvent. Do not submerge the ignition coils in solvent.
    • Do not remove the oil fill tube from the covers unless service is required. If the tube is removed from the cover, install a NEW tube (423) and seal (422) during assembly.
  1. Inspect the oil fill tube (423) for a loose fit or damage.
  2. Inspect the covers (505) for the following conditions:
    • Scoring or damage to the gasket surfaces
    • Ventilation system passages for restrictions
    • Threaded bolt holes for damage or debris
scientia non olet · About LEMON Manuals