Throttle Body Assembly Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Throttle Body Assembly

GM1401966

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the throttle body studs, as required. Tighten the throttle body studs to 6 N.m (53 lb in).

NOTE:

DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.

Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
Install the throttle body (508), bolts (538), and nuts (507). Tighten the throttle body nuts and bolts to 10 N.m (89 lb in).