LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - Hybrid ( LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of PCV Dirty-Air Hose
    GM1658148Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.
    • DO NOT use the intake manifold-to-cylinder head gaskets again.
  1. Remove the positive crankcase ventilation (PCV) hose - dirty air (716).
    2. Fig 2: MAP Sensor
    GM1401987Courtesy of GENERAL MOTORS COMPANY
  2. Remove the manifold absolute pressure (MAP) sensor (714) and retainer (736), as required.
  3. Remove the O-ring (715) from the sensor, as required.
    4. Fig 3: Intake Manifold
    GM1401989Courtesy of GENERAL MOTORS COMPANY
  4. Remove the intake manifold bolts (512).
  5. Remove the intake manifold (500) with gaskets.
    6. Fig 4: View Of Intake Manifold-To-Cylinder Head Gasket
    GM1277097Courtesy of GENERAL MOTORS COMPANY
  6. Remove the intake manifold gaskets (514).
  7. Discard the intake manifold gaskets.
scientia non olet · About LEMON Manuals