Measuring Connecting Rod Bearing Clearance - Gaging Plastic Method

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Gaging Plastic Installed On Crankshaft Journal

GM4980

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Connecting rod bearings are a precision insert type. Connecting rods are of a powdered metal design and cannot be shimmed or filed for bearing fit. If clearances are found to be excessive, a new bearing and/or connecting rod is required.
Do not rotate the crankshaft while gaging plastic is between the crankshaft journal and the bearing surface.

Remove the bearing cap, bearing half, and bolts. Refer to Piston, Connecting Rod, and Bearing Removal .
Install the gaging plastic onto the connecting rod bearing journal. Install the gaging plastic the full width of the journal.
Install the bearing cap, bearing half, and bolts. Refer to Piston, Connecting Rod, and Bearing Installation .
Remove the bearing cap, bearing half, and bolts. Refer to Piston, Connecting Rod, and Bearing Removal .

Fig 2: Measuring Gaging Plastic

GM4981

Courtesy of GENERAL MOTORS COMPANY

Using the scale supplied with the plastic gaging kit, measure the gaging plastic at its widest area. Refer to Engine Mechanical Specifications .