Crankshaft Balancer Removal

Special Tools

• J 41816-A  Crankshaft Balancer Remover
• J 41816-2  Crankshaft End Protector
• J 42386-A  Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools

Fig 1: View Of Special Tool & Bolts
Courtesy of GENERAL MOTORS COMPANY
CAUTION:

Refer to Fastener Caution .

NOTE:

Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

1. Install the J 42386-A  tool (1) and bolts.

   Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten the J 42386-A  tool bolts to 50 N.m (37 lb ft).

Fig 2: View Of Crankshaft Balancer Bolt
Courtesy of GENERAL MOTORS COMPANY
2. Remove the crankshaft balancer bolt (139). Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
Fig 3: Removing Crankshaft Balancer
Courtesy of GENERAL MOTORS COMPANY
3. Use the J 41816-A  remover (1) and the J 41816-2  protector (2) in order to remove the crankshaft balancer.
Fig 4: View Of Crankshaft Balancer
Courtesy of GENERAL MOTORS COMPANY
4. Remove the balancer (138).
Fig 5: View Of Special Tool & Bolts
Courtesy of GENERAL MOTORS COMPANY
5. Remove the J 42386-A  tool (1) and bolts.