LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - Hybrid ( LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Retainer & Retainer Bolt
    GM1969013Courtesy of GENERAL MOTORS COMPANY
  1. Remove the camshaft retainer bolts (204) and retainer (203).
    2. Fig 2: View Of Camshaft
    GM1704626Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

  2. Remove the camshaft.
    1. Install the camshaft sprocket bolt into the camshaft front bolt hole.
    2. Using the bolt as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolt from the front of the camshaft.
scientia non olet · About LEMON Manuals