LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - Hybrid ( LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Installation

Camshaft Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft
    GM1704626Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If camshaft replacement is required, the valve lifters must also be replaced.

  1. Lubricate the camshaft journals and the bearings with clean engine oil.
  2. Install the camshaft sprocket bolt into the camshaft front bolt hole.
    3. CAUTION:

    All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

  3. Using the bolt as a handle, carefully install the camshaft into the engine block.
  4. Remove the bolt from the front of the camshaft.
    5. Fig 2: View Of Camshaft Retainer & Retainer Bolt
    GM1969013Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The gasket surface on the engine block should be clean and free of dirt or debris.

  5. Install the camshaft retainer (203) and the bolts (204). Install the retainer with the sealing gasket facing the front of the engine block.
    6. Fig 3: View Of Camshaft Retainer & Bolt
    GM1967334Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  6. Tighten the camshaft retainer TORX® head bolts to 15 N.m (11 lb ft).
scientia non olet · About LEMON Manuals