LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Rocker Arm Cover Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Connector Position Assurance (CPA) Retainer, Connector & Clips
    GM1965798Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Remove the connector position assurance (CPA) retainer (2).
  3. Disconnect the engine harness electrical connector (1) from the ignition coil wire harness.
  4. Remove two engine harness clips (3) from the ignition coil bracket studs.
  5. Reposition the engine harness, as necessary.
    6. Fig 2: Ignition Coils & Bracket
    GM1402016Courtesy of GENERAL MOTORS COMPANY
  6. Remove the spark plug wires (724) from the ignition coils.
    • Twist each plug wire 1/2 turn.
    • Pull only on the boot in order to remove the wire from the ignition coil.
  7. Remove the ignition coil bracket studs (720).
  8. Remove the ignition coil bracket (719).
    9. Fig 3: View Of PCV Hose
    GM1696791Courtesy of GENERAL MOTORS COMPANY
  9. Remove the positive crankcase ventilation (PCV) hose.
    10. Fig 4: View Of Valve Rocker Arm Cover
    GM1277108Courtesy of GENERAL MOTORS COMPANY
  10. Loosen the valve rocker arm cover bolts.
  11. Remove the valve rocker arm cover.
    12. Fig 5: Rocker Arm Cover Gasket
    GM490696Courtesy of GENERAL MOTORS COMPANY
  12. Remove and discard the old gasket (1).
scientia non olet · About LEMON Manuals