LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Pump, Screen, and Crankshaft Oil Deflector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pump Screen & O-Ring Seal
    GM647800Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil pan. Refer to Oil Pan Replacement (4WD) , Oil Pan Replacement (2WD) .
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
  3. Remove the oil pump screen bolt and nuts.
  4. Remove the oil pump screen with O-ring seal.
  5. Remove the O-ring seal from the pump screen.
  6. Discard the O-ring seal.
    7. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS COMPANY
  7. Remove the remaining crankshaft oil deflector nuts.
  8. Remove the crankshaft oil deflector.
    9. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS COMPANY
  9. Remove the oil pump bolts (411).
    10. NOTE:

    Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.

  10. Remove the oil pump (413)
scientia non olet · About LEMON Manuals