Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS COMPANY

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Install NEW oil pressure sensor filter (452).

CAUTION:

Using J 41712 oil pressure switch socket or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten

Tighten the sensor to 35 (26 lb ft).

Fig 2: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS COMPANY

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten

Tighten the sensor to 35 (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement .