LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount
    GM1701536Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701534Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Working through the wheelhouse opening, install the engine mount to engine bolts (1).

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack from the engine block.
    5. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701531Courtesy of GENERAL MOTORS COMPANY
  5. Install the engine mount to frame bolts (1).

    Tighten 

    Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.

  6. Install the A/C compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (HP2) .
  7. If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.

    Tighten 

    Tighten the bolts to 90 N.m (67 lb ft).

  8. If the vehicle is equipped with 4WD, Install the front drive axle. Refer to Differential Carrier Assembly Replacement (9.25 Inch Axle) , Differential Carrier Assembly Replacement (8.25 Inch Axle) .
  9. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side .
scientia non olet · About LEMON Manuals