LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

    Fig 1: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Lower the vehicle.
  3. Remove the engine mount to frame bolts (1).
  4. Raise and support the vehicle halfway. Refer to Lifting and Jacking the Vehicle .
  5. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
    6. Fig 2: View Of Engine Block Tab
    GM1710769Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    DO NOT raise and/or support the engine by the crankshaft balancer, or the oil pan.

  6. Place an adjustable (screw type) jack to the tab (1) located on the engine block.
    7. Fig 3: View Of Engine Mount To Engine Bolts
    GM1701533Courtesy of GENERAL MOTORS COMPANY
  7. Working through the wheelhouse opening, remove the engine mount to engine bolts (1).
  8. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
    9. Fig 4: View Of Engine Mount
    GM1701535Courtesy of GENERAL MOTORS COMPANY
  9. Remove the engine mount.
scientia non olet · About LEMON Manuals