LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Hybrid/EV Cooling System) >> Diagnostic Information and Procedures >> DTC P0AAD-P0AAF or P0AB2-P0AB4 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify that DTC P0A80, P0A81 or P0BBD is not set.
  2. Ignition ON, using a scan tool, command the hybrid battery pack fan speed to 60 percent and let it run for 2 minutes.
  3. Observe the scan tool hybrid battery air inlet and outlet temperature parameters. The readings should be between -39 and +95°C (-38.2 and +203°F) with no greater than a 10°C (50°F) difference. Refer to Temperature Versus Resistance .
scientia non olet · About LEMON Manuals