Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0116, P0117, P0118, P0125, P0128, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0606, P1516, P2101, P2135, P2176 are not set.
The ignition voltage is between 10-32 volts.
The engine speed is between 900-2,500 RPM.
The mass air flow (MAF) is between 3-20 g/s.
The vehicle speed is between 70-130 km/h (43.5-80.8 mph).
The fuel level is greater than 10 percent.
The fuel system is in Closed Loop.
The catalytic converter temperature is between 550-900°C (1,022-1,652°F).
The DTCs run once per ignition cycle when the above conditions are met. DTCs are allowed to run more than once per ignition cycle after a code clear or an ECM reflash.