Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0050, P0053, P0059, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0151, P0152, P0153, P0154, P0155, P015A, P015B, P015C, P015D, P0201-P0208, P0220, P0222, P0223, P0300, P0301-P0308, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0606, P0641, P0651, P1516, P2101, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, or P2176 are not set.
Device controls are not active.
All intrusive diagnostics are not active.
The engine overspeed protection is not active.
The power take-off (PTO) is not active.
The traction control is not active.
The engine is in Closed Loop status.
The ignition voltage is between 10-32 V for greater than 4 s.
The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
The engine speed is between 425-6,000 RPM.
The mass air flow is between 0.5-510 g/s.
The fuel ethanol content is less than 87 percent.
These DTCs run continuously when the above conditions have been met.