Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0171, P0172, P0174, P0175, P0201-P0208, P0220, P0222, P0223, P0300-P0308, P0351-P0358, P0461- P0463, P0496, P0606, P0722, P0723, P1516, P2066-P2068, P2101, P2135 are not set.
- The engine is operating for at least 60 s.
- The barometric pressure (BARO) is greater than 70 kPa (11 psi).
- The engine coolant temperature (ECT) is greater than 60°C (140°F).
- The system voltage is between 11-32 V.
- The transmission is not changing gears.
- The torque converter clutch (TCC) is not changing states.
- The intake air temperature (IAT) is warmer than -20°C (-4°F).
- The manual transmission clutch pedal position is between 20-88 percent, If equipped.
- The transfer case is not in 4WD Low - If equipped.
- The vehicle speed is less than 3 km/h (2 mph).
- The commanded engine speed is steady within 25 RPM.
- The engine is idling for greater than 5 s.
- A scan tool output control is not active.
- DTC P0506 and P0507 run continuously when the above conditions are met for greater than 10 s.