LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0351 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0443 or P0449 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

An ignition voltage is supplied directly to the evaporative emission (EVAP) purge solenoid valve. The engine control module (ECM) grounds the EVAP purge solenoid valve control circuit through an internal switch called a driver. The ECM monitors the status of the driver. The EVAP purge solenoid valve is pulse width modulated (PWM). A scan tool will display the amount of ON time as a percentage.

Battery voltage is supplied to the EVAP vent solenoid valve. The ECM grounds the EVAP vent solenoid valve control circuit through an internal switch called a driver. The ECM monitors the status of the driver. A scan tool will display the commanded state of the EVAP vent solenoid valve as ON (Not Venting) or OFF (Venting).

scientia non olet · About LEMON Manuals