Conditions for Running the DTC

P0335 Condition 1

• The starter is engaged and the engine control module detects camshaft position (CMP) sensor pulses.

  OR

• DTCs P0101, P0102 and P0103 are not set.
• The airflow into the engine is greater than 3 g/s.

Condition 2

• The engine is running and starter not engaged.
• DTC P0651 is not set.

Condition 3

• The engine is running or the starter is engaged.
• DTCs P0340, P0341, P0641, or P0651 are not set.

P0336 Condition 1

• The airflow into the engine is greater than 3 g/s.
• The engine speed is greater than 450 RPM.
• DTCs P0335 or P0641 are not set.

Condition 2

• The engine is running and the starter is not engaged.
• DTC P0651 is not set.

Condition 3

• The starter is engaged and the engine control module detects camshaft position (CMP) sensor pulses.

  OR

• DTCs P0101, P0102 and P0103 are not set.
• The airflow into the engine is greater than 3 g/s.

Condition 4

• The engine is running or the starter is engaged.
• DTCs P0340, P0341, P0641, or P0651 are not set.

The DTCs run continuously once the above conditions are met.