Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0010, P0011, P0016, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0220, P0222, P0223, P0335, P0336, P0606, P0641, P0651, P1516, P2101, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, and P2176 are not set.
- When DTC P0315 is set, the engine speed must be more than 1,000 RPM.
- Engine run time is more than 2 crankshaft revolutions.
- The engine speed is between 375-5,600 RPM.
- The ignition voltage is between 9-18 volts.
- The engine coolant temperature (ECT) is between -7 and +130°C (+19 and +266°F).
- When the startup ECT is colder than -7°C (+19°F), this diagnostic will be delayed until the ECT is warmer than +21°C (+69°F).
- The fuel level is more than 10 percent.
- The ECM is not in fuel shut-off, or decel fuel cut-off mode.
- The electronic brake control module (EBCM) and the traction control system (TCS) are not active or detecting rough road.
- An automatic transmission shift with a throttle position more than 95 percent is not occuring.
- The power management is not active.
- Excessive drive wheel slip is not detected.
- The power take-off (PTO) is disabled, where applicable.
- The cylinder deactivation is not in progress, where applicable.
- DTCs P0300-P0308 run continuously when the above conditions are met.