LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207, or P0208 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:

The engine coolant temperature (ECT) sensor must be between 10-32°C (50-90°F) for an accurate measurement.

  1. Ignition OFF, disconnect the harness connector at the appropriate fuel injector.
  2. Test for 11-14 Ω between the terminals of the fuel injector.
    • If not within the specified range, replace the fuel injector.
  3. Test for infinite resistance between each terminal and the fuel injector housing/case.
    • If not the specified value, replace the fuel injector.
scientia non olet · About LEMON Manuals