Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
Engine idling, observe the following control circuit status parameters for each fuel injector:
- Cyl. 1-8 Injector Ckt Short Gnd Test Status
- Cyl. 1-8 Injector Ckt Open Test Status
- Cyl. 1-8 Injector Ckt Short Volts Test Status
  Each parameter should display OK or Not Run.
Engine running, observe the DTC information with a scan tool. DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207, or P0208 should not set.
Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.