LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0112 or P0113 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify the scan tool IAT parameter is colder than -39°C (-38°F).
    • If warmer than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal B and ground. Verify the scan tool IAT parameter is warmer than 149°C (300°F).
    • If colder than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the MAF/IAT sensor.
scientia non olet · About LEMON Manuals