LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0069 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the affected sensor.
  2. Ignition OFF for 90 seconds or until the ECM powers down, test for less than 5 ohms between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 1 and ground.
    • If less than the specified range, test the 5-volt reference circuit 1 for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Verify the scan tool sensor parameter is less than 2 kPa.
    • If greater than the specified range, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition OFF for 90 seconds or until the ECM powers down, install a 3A fused jumper wire between the signal circuit terminal 3 and the 5-volt reference circuit terminal 1. Key ON, verify the scan tool sensor parameter is greater than 126 kPa.
    • If less than the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  6. If all circuits test normal, test or replace the affected sensor.
scientia non olet · About LEMON Manuals