Vehicle Speed Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Vehicle Speed Sensor & O-Ring

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
1	Vehicle Speed Sensor CAUTION: Refer to Fastener Caution . Procedure Disconnect vehicle speed sensor electrical connector. Tighten 17 N.m (13 lb ft)
2	Vehicle Speed Sensor O-ring Procedure Lightly lubricate the O-ring with clean DEXRON® VI.

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .

Vehicle Speed Sensor

CAUTION:

Procedure
Disconnect vehicle speed sensor electrical connector.
Tighten
17 N.m (13 lb ft)

Vehicle Speed Sensor O-ring
Procedure
Lightly lubricate the O-ring with clean DEXRON® VI.