Rear Output Shaft Assembly Disassemble
WARNING: This page is about a different variant/trim than selected.
Rear Output Shaft Assembly Disassemble
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Rear Output Shaft Rear Bearing Retaining Ring |
| 2 | Transfer Case Rear Output Shaft Rear Bearing Assembly
NOTE:
Use an arbor press or suitable puller to remove the bearing from the rear output shaft. |
| 3 | Transfer Case Rear Output Shaft Rear Bearing Retaining Ring - Present on Non-Hybrid Applications Only |
| 4 | Transfer Case Rear Output Shaft Speed Reluctor Wheel |
| 5 | Transfer Case Oil Pump Assembly |
| 6 | Transfer Case Front Output Shaft Drive Sprocket Retaining Ring |
| 7 | Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear |
| 8 | Transfer Case Front Output Shaft Drive Sprocket |
| 9 | Transfer Case Four Wheel Drive Clutch Housing Retaining Ring |
| 10 | Transfer Case Four Wheel Drive Clutch Housing |
| 11 | Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly (Qty: 2)
NOTE:
Only remove the bearing if faulty. Refer to Drive Chain, Drive Sprocket, and Driven Sprocket Cleaning and Inspection . |
| 12 | Transfer Case Front Output Shaft Drive Sprocket Spacer - Front |
| 13 | Transfer Case Two/Four Wheel Drive Clutch Retaining Ring |
| 14 | Transfer Case Four Wheel Drive Clutch Shim |
| 15 | Transfer Case Four Wheel Drive Clutch Hub |
| 16 | Transfer Case Four Wheel Drive Clutch Pressure - Friction - Plate (Qty: 8) |
| 17 | Transfer Case Four Wheel Drive Clutch Pressure - Steel - Plate (Qty: 7) |
| 18 | Transfer Case Four Wheel Drive Clutch Pressure Plate Spring (Qty: 4) |
| 19 | Transfer Case Four Wheel Drive Clutch Pressure - Apply - Plate |
| 20 | Transfer Case Control Actuator Lever Washer |
| 21 | Transfer Case Control Actuator Lever Thrust Bearing Assembly |
| 22 | Transfer Case Control Actuator Lever Assembly
NOTE:
When replacing control actuator levers or lever balls on NPO or NQH applications, refer to New Product Information . |
| 23 | Transfer Case Control Actuator Lever Ball (Qty: 3) |
| 24 | Transfer Case Control Actuator Lever Bearing Assembly |
| 25 | Transfer Case Control Lever
NOTE:
When replacing control actuator levers or lever balls on NPO or NQH applications, refer to New Product Information . |
| 26 | Transfer Case Control Actuator Lever Thrust Bearing Assembly |
| 27 | Transfer Case Rear Output Shaft |