LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Mp 3023/3024-NQH) >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble >> Input Shaft Oil Seal Removal

Input Shaft Oil Seal Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Illustrating Proper Input Shaft Oil Seal Installation
GM2249581Courtesy of GENERAL MOTORS COMPANY
Input Shaft Oil Seal Removal

Callout Component Name
1 Input Shaft Oil Seal
CAUTION:

Refer to Machined Surface Damage Caution .

Procedure

  1. Drill a pilot hole, as required, and insert a self-tapping screw into the body of the seal.
  2. Use a plier or slide hammer type tool to remove the seal from the bore.
scientia non olet · About LEMON Manuals