Rear Output Shaft Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Cleaning and Inspection

GM1849354

Courtesy of GENERAL MOTORS COMPANY

Rear Output Shaft Cleaning and Inspection

Callout	Component Name
Preliminary Procedure Inspect all components or sub-components and perform any repair procedure necessary to fix the damage. If the damage cannot be repaired, replace the component or sub-component as indicated. Clean all components in cleaning solvent and air dry.
1	Transfer Case Rear Output Shaft Splines NOTE: Witness marks at the location of the yoke are normal.
2	Transfer Case Oil Pump and Rear Output Shaft Speed Reluctor Wheel Engagement Splines NOTE: Witness marks at the location of the components are normal.
3	Transfer Case Front Output Shaft Drive Sprocket Bearing Surface NOTE: Inspect for scoring, brinelling, pitting, or excessive wear.
4	Transfer Case Two/Four Wheel Drive Clutch Hub Engagement Splines NOTE: Witness marks at the location of the hub is normal.
5	Transfer Case Control Actuator Lever Bearing Surface NOTE: Inspect for scoring, brinelling, pitting, or excessive wear.
6	Transfer Case Control Actuator Lever Thrust Bearing Surface NOTE: Inspect for scoring, brinelling, pitting, or excessive wear.
7	Transfer Case High/Low Clutch Engagement Splines NOTE: Witness marks at the location of the high/low clutch is normal.
8	Transfer Case Input Shaft Pilot Bearing Surface NOTE: Inspect for scoring, brinelling, pitting, or excessive wear.
9	Oil Galleries NOTE: Compressed air may be necessary to clean the oil galleries.