LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Mp 3023/3024-NQH) >> Diagnostic Information and Procedures >> Transfer Case High/Low Clutch Reset >> Using The Transfer Case Shift Control Switch

Using The Transfer Case Shift Control Switch

WARNING: This page is about a different variant/trim than selected.
NOTE:

The Learn procedure is performed with the ignition in the ACCESSORY position. The shift to transfer case NEUTRAL procedure uses this same procedure, but with the key in the RUN position.

  1. Key OFF for at least 30 seconds.
  2. Engage parking brake.
  3. Place transmission in Neutral.
  4. Turn the transfer case shift control switch (TCSCS) to the 2WD HI position for at least 5 seconds.
  5. Turn the TCSCS clockwise past the 4WD LO position to the neutral request position and hold for at least 30 seconds.
  6. An audible noise from the transfer case encoder motor should occur indicating a successful learn procedure.
scientia non olet · About LEMON Manuals