LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Mp 3023/3024-NQH) >> Diagnostic Information and Procedures >> DTC P2160 or P2161 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Key OFF. Let sit for 2 minutes to ensure that the ECM shuts down.
  2. Disconnect the X1 connector from the VSS. Using the J 35616-2A GY probes, test for less than 0.1 V between the following circuits and a good ground.
    • VSS high signal circuit, VSS harness X1 pin A.
    • VSS low signal circuit, VSS harness X1 pin B.
      • If the voltage is greater than the specified value, test the affected circuit for a short to voltage. If all circuits and connections test normal, test the ECM for proper operation.
  3. Key ON, engine OFF. Test for a diagnostic 2-3 V (low current) between the following circuits and a good ground.
    • VSS high signal circuit, VSS harness X1 pin A.
    • VSS low signal circuit, VSS harness X1 pin B.
      • If the voltage is less than the specified value, test the affected circuit for an open/high resistance, short to ground or short together. If all circuits and connections test normal, test the ECM for proper operation.
      • If the voltage is greater than the specified value, test the affected circuit for a short to voltage. If all circuits and connections test normal, test the ECM for proper operation.
  4. Test the VSS for proper operation.
scientia non olet · About LEMON Manuals