LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Transfer Case - Mp 3023/3024-NQH) >> Diagnostic Information and Procedures >> DTC B2725 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Key OFF. Disconnect the X1 connector at the transfer case shift control switch (TCSCS). Install EL-49742  harness.
    2. NOTE:

    When test probing harness terminals, it is imperative to use the proper test probe from the most current version of the J 35616  GM terminal test kit. Use of an improper test probe may deform the terminal, resulting in intermittent open conditions.

  2. Key ON (Ignition C), engine OFF.
  3. Using the L-BU probes J 35616-64B, test for 4.86-5.25 V between the 5-volt reference circuit, TCSCS X1 pin 11, and the ground terminal of EL-49742  harness, black terminal.
    • If the voltage is less than the specified value, test the 5-volt reference circuit for an open/high resistance or short to ground condition. If all circuits and connections test normal, test the TCCM for proper operation.
    • If the voltage is greater than the specified value, test the 5-volt reference circuit for a short to voltage. If all circuits and connections test normal, test the TCCM for proper operation.
  4. Using the L-BU probes J 35616-64B, test for 4.86-5.25 V between the 5-volt reference circuit, TCSCS X1 pin 11, and the switch signal circuit TCSCS X1 pin 12.
    • If the voltage is less than the specified value, test the switch signal circuit for an open/high resistance, short to ground or short together. If all circuits and connections test normal, test the TCCM for proper operation.
    • If the voltage is greater than the specified value, test the switch signal circuit for a short to voltage. If all circuits and connections test normal, test the TCCM for proper operation.
  5. Using the L-BU probes J 35616-64B, test for greater than 500 Ω between the 5-volt reference circuit, TCSCS X1 pin 11, and all other pins of the TCSCS X1.
    • If the resistance is less than the specified value, test the affected circuits for short together condition. If all circuits and connections test normal, test the TCCM for proper operation.
  6. Using the L-BU probes J 35616-64B, test for greater than 500 Ω between the switch signal circuit TCSCS X1 pin 12, and all other pins of the TCSCS X1.
    • If the resistance is less than the specified value, test the affected circuits for short together condition. If all circuits and connections test normal, test the TCCM for proper operation.
  7. Test the TCSCS for proper operation.
scientia non olet · About LEMON Manuals