Component Replacement - Conversion from First Design to Second Design
WARNING: This page is about a different variant/trim than selected.
It is possible to repair a first-design assembly using second-design components. Refer to the parts catalog and the tables above for component part number clarification.
NOTE:
First-design LD components are shown in the view above.
When servicing a first-design assembly with second-design components, the following components MUST be replaced as a group:
- Front Case Half Assembly - with internal gear and retaining ring
- Locking Plate
- Thrust Washer (front)
- Input Shaft
- Pilot Bearing
- Thrust Washer (rear)
- Planetary Carrier Assembly
- High/Low Clutch