LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Knock Sensor Electrical Connector & Sleeve
    GM1965285Courtesy of GENERAL MOTORS COMPANY
  1. If equipped with 4WD, remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  2. Remove the left front wheel and tire. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel) , Tire and Wheel Removal and Installation (8-Lug Wheel) .
  3. Working through the wheel well opening, reposition the engine wiring harness sleeve (3).
  4. Disconnect the engine wiring harness electrical connector (4) from knock sensor.
    5. Fig 2: Left Side Knock Sensor & Bolt
    GM1402136Courtesy of GENERAL MOTORS COMPANY
  5. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals