Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- If equipped with 4 wheel drive (4WD), remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
- Disconnect the chassis wiring harness electrical connector (1) from the fuel pressure sensor (2).
- Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
- Remove the fuel pressure sensor (1) from the fuel line.
- Remove and discard the fuel pressure sensor O-ring seal (2).
Fig 1: View Of Chassis Wiring Harness Electrical Connector, Fuel Pressure Sensor, Fuel Pipe Bracket & Wiring Harness Clip