LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Level Sensor Tangs & Retainer
    GM1704575Courtesy of GENERAL MOTORS COMPANY
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement .
  2. Using a small pick like tool, push in the retainer (1) in order to disengage the electrical connector.
  3. Remove the fuel level sensor electrical connector from the module cover.
  4. Push the level sensor locking tangs (2) in towards the inside of the module bucket.
    5. Fig 2: View Of Fuel Level Sensor At Sending Unit Bucket (4.8L & 5.3L)
    GM1341846Courtesy of GENERAL MOTORS COMPANY
  5. Slide the fuel level sensor up.
    6. Fig 3: View Of Fuel Level Sensor
    GM1704577Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fuel level sensor from the module.
scientia non olet · About LEMON Manuals