LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:

Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.

    Fig 1: View Of EVAP Pipe & Clips
    GM1965576Courtesy of GENERAL MOTORS COMPANY
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the EVAP pipe quick connect fitting from the auxiliary EVAP canister. (Body shown removed for clarity). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP pipe quick connect fitting from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Remove the EVAP pipe clip (2) from the frame crossmember.
  5. Remove the EVAP pipe clip (1) from the rear brake front pipes.
  6. Remove the EVAP pipe (3) from the vehicle.
scientia non olet · About LEMON Manuals