LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:

Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.

    Fig 1: View Of Fuel Tank Shield & Retainers
    GM1704741Courtesy of GENERAL MOTORS COMPANY
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Remove the fuel tank shield retainers (2, and 3) and shields (1, and 4).
    3. Fig 2: View Of Fuel Tank Clips
    GM1704505Courtesy of GENERAL MOTORS COMPANY
  3. Remove the EVAP lines from the fuel tank clips (2, and 6).
  4. Open the fuel tank clips (1, 3, 4, and 5) and remove the EVAP lines from the clips.
  5. Disconnect the EVAP line quick connect fittings at the fuel tank module and vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: View Of Fuel Tank EVAP Lines
    GM1704507Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals