LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: EVAP Canister Vent Solenoid Retainer
    GM2759400Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP canister vent solenoid.
  2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.
    3. Fig 2: EVAP Canister Vent Solenoid Quick Connect Fitting
    GM2759395Courtesy of GENERAL MOTORS COMPANY
  3. Connect the EVAP canister vent solenoid quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 3: Solenoid Vent Filter
    GM2759392Courtesy of GENERAL MOTORS COMPANY
  4. Connect the solenoid vent filter (2) to the fill pocket with a new push pin (1).
    5. Fig 4: 2 Tie Straps
    GM2759398Courtesy of GENERAL MOTORS COMPANY
  5. Install 2 tie straps (1) to hold the solenoid vent line to the fuel fill pipe hose.
    6. Fig 5: View Of EVAP Canister Vent Solenoid Electrical Connector
    GM1706529Courtesy of GENERAL MOTORS COMPANY
  6. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
  7. Lower the vehicle.
  8. Install the spare tire and wheel assembly.
scientia non olet · About LEMON Manuals