LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE:

Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

    Fig 1: Locating Quick Connect Fittings
    GM1964897Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank EVAP line quick connect fitting (3) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the fuel tank EVAP line quick connect fitting (2) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disconnect the EVAP pipe quick connecting fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 2: View Of EVAP Canister Assembly & Bolts
    GM1964898Courtesy of GENERAL MOTORS COMPANY
  5. Remove the EVAP canister bracket bolts (1).
  6. Remove the EVAP canister assembly (2) from the tab on the frame bracket.
    7. Fig 3: View Of EVAP Canister, Bracket & Bolt
    GM1964900Courtesy of GENERAL MOTORS COMPANY
  7. Remove the EVAP canister bolt (1).
  8. Remove the EVAP canister (2) from the bracket (3).
scientia non olet · About LEMON Manuals