LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2022 (Transfer Case - Mp 3010-NP0) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Tahoe, 2013 Chevrolet Suburban, and 2013 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Output Shaft Oil Seal And Installer
    GM2716858Courtesy of GENERAL MOTORS COMPANY
  1. Using the J-8092  driver handle and DT-50649  installer (2) install the front output shaft oil seal (1) to the transfer case.
    2. Fig 2: Front Output Shaft Oil Slinger And Special Installer Tool
    GM2716856Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The new design front output shaft oil slinger can be installed onto all current and prior model year applications, providing the new design front output shaft seal is also installed. Refer to Transfer Case Description and Operation .

  2. Using the J-8092  driver handle and DT-50649  installer (2) install the front output shaft oil slinger (1) to the transfer case.
  3. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals