LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2022 (Transfer Case - Mp 3010-NP0) >> Repair Instructions - On Vehicle >> Drain Plug Replacement

Drain Plug Replacement

WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Tahoe, 2013 Chevrolet Suburban, and 2013 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transfer Case Drain Plug & Fill Plug
GM1836287Courtesy of GENERAL MOTORS COMPANY
Drain Plug Replacement

Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
1 Transfer Case Drain Plug
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Allow the transfer case to drain completely.
  2. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the plug threads.

TIP:  Use only hand tools to remove and install the drain plug.
Tighten 
18 N.m (13 lb ft)
2 Transfer Case Fill Plug

Procedure

  1. Fill the transfer case to the bottom of the fill plug hole with DEXRON® VI GM P/N 88861003 (Canadian P/N 88861004).
  2. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the plug threads.

TIP:  Use only hand tools to remove and install the fill plug.
Tighten 
18 N.m (13 lb ft)